Jenn-Air JMW2427 Benutzerhandbuch

Seite von 56
10
OVEN USE
Odors and smoke are normal when the oven is used the first few 
times, or when it is heavily soiled.
During oven use, the heating elements will not remain on, but will 
cycle on and off throughout oven operation.
IMPORTANT: The health of some birds is extremely sensitive to 
the fumes given off. Exposure to the fumes may result in death to 
certain birds. Always move birds to another closed and well- 
ventilated room.
Aluminum Foil
IMPORTANT: To avoid permanent damage to the oven bottom 
finish, do not line the oven bottom with any type of foil or liner.
For best cooking results, do not cover entire rack with foil 
because air must be able to move freely.
To catch spills, place foil on rack below dish. Make sure foil is 
at least ½" (1.3 cm) larger than the dish and that it is turned 
up at the edges.
Positioning Racks and Bakeware
IMPORTANT: To avoid permanent damage to the porcelain 
finish, do not place food or bakeware directly on the oven door or 
bottom.
RACKS
Position racks before turning on the oven. 
Do not position racks with bakeware on them. 
Make sure racks are level. 
Depending on the oven model, you could have flat, offset and/or 
roll-out racks. If “f” is after the rack position, the flat rack should 
be used. An “o” after the rack position indicates the offset rack 
should be used. An “r” indicates the roll-out rack should be used. 
For example: 1o, 3f, 5r indicates the use of the offset rack in rack 
position 1, the flat rack in position 3, and the roll-out rack in 
position 5. Refer to the section for the mode you are using for 
specific rack recommendations.
27" (68.6 cm) Rack Positions
30" (76.2 cm) Rack Positions
BAKEWARE
To cook food evenly, hot air must be able to circulate. Allow 
2" (5.0 cm) of space around bakeware and oven walls. 
Roll-Out Rack
The roll-out rack allows easy access to position and remove food 
in the oven. The roll-out rack will fit in all positions.
Open Position
Closed and Engaged Position
To Insert Roll-Out Rack
1. Angle rack assembly up and insert into the “V” cutout in the 
rack guides of the oven cavity. 
2. Keep rack lifted up at an angle and push in to bypass the 
lower “V” cutout.
3. Gently slide rack into oven, bypassing the “V” cutouts. 
1
2
3
4
1
2
3
4
5
A. Slide rails
B. Sliding shelf
A. Slide rails
B. Sliding shelf
A. Rack guide
B. “V” cutout
A
B
B
A
A
B