Beko lxd 6145 b Benutzerhandbuch
EN
8
3
Installation
Transportation Instructions
1. The appliance should be transported
only in a vertical upright position. The
packing as supplied must be intact
during transportation.
packing as supplied must be intact
during transportation.
2. If during the course of transport the
appliance has to be transported
horizontally, the product must only
be laid on its right hand side (when
facing the door front) and it must not
be operated for at least 4 hours to
allow the system to settle after the
appliance is brought back to upright
position.
horizontally, the product must only
be laid on its right hand side (when
facing the door front) and it must not
be operated for at least 4 hours to
allow the system to settle after the
appliance is brought back to upright
position.
3. Failure to comply with the instructions
could result in damage occurring
to the appliance. The manufacturer
will not be held responsible if these
instructions are disregarded.
to the appliance. The manufacturer
will not be held responsible if these
instructions are disregarded.
4. The appliance must be protected
against rain, moisture and other
atmospheric influences.
atmospheric influences.
5. When positioning your appliance take
care not to damage your flooring,
pipes, wall coverings etc. Do not
move the appliance by pulling by the
door or handle.
pipes, wall coverings etc. Do not
move the appliance by pulling by the
door or handle.
6. Empty any water in the drain tray and
Water Dispenser tank before moving.
See section ‘Defrosting’ and ‘Care &
cleaning’ for further information.
See section ‘Defrosting’ and ‘Care &
cleaning’ for further information.
7. Make sure that the defrost water pipe
at the back of the product is fixed
to the plastic evaporating pan on
the top of the compressor, to avoid
defrost water spillage on the floor.
to the plastic evaporating pan on
the top of the compressor, to avoid
defrost water spillage on the floor.
Important Care must be taken
when carrying the appliance to avoid
touching the bottom of the condenser
metal support/pipework at the back of
the appliance as you might injure your
fingers and hands or damage your
product.
touching the bottom of the condenser
metal support/pipework at the back of
the appliance as you might injure your
fingers and hands or damage your
product.
Important :
Make sure that mains cable is not
caught under the appliance during and
after carrying/moving the appliance, to
avoid the mains cable becoming cut or
damaged.
Do not attempt to sit or stand on top
of your appliance. You could injure
yourself and damage the appliance.
BEKO declines to accept any
caught under the appliance during and
after carrying/moving the appliance, to
avoid the mains cable becoming cut or
damaged.
Do not attempt to sit or stand on top
of your appliance. You could injure
yourself and damage the appliance.
BEKO declines to accept any
liability should the instructions not be
followed.
followed.
Installation Instructions
1. Fit the two plastic wall spacers
supplied with the appliance onto
the condenser at the back of the
appliance by rotating 1/4 turn.
the condenser at the back of the
appliance by rotating 1/4 turn.
2. Locate the appliance on a smooth
surface.
3. To ensure it is standing upright
adjust the two front feet by turning
clockwise or anti-clockwise, until it is
in firm contact with the floor. Correct
adjustment of feet avoids excessive
vibration and noise.
clockwise or anti-clockwise, until it is
in firm contact with the floor. Correct
adjustment of feet avoids excessive
vibration and noise.