Beko TF546APW Benutzerhandbuch

EN

7

1. The space in the room where the 
appliance is installed must not be 
smaller than 10 cubic metres.

2. If possible avoid placing the 
appliance near cookers, radiators or 
in direct sunlight as this will cause the 
compressor to run for long periods. 
If installed next to a source of heat 
or refrigerator, maintain the following 
minimum side clearances:

     From Cookers   

  2”   (50 mm)

     From Radiators   

12” (300 mm)

     From Refrigerators or Freezers     1”   
(25 mm)
3. Make sure that sufficient room 
is provided around the appliance 
to ensure free  air circulation. Allow 
a minimum of 60 mm (2.4 inches) 
between the top of the appliance and 
the ceiling or the underside of a wall 
cupboard.
4. Fit the two plastic wall spacers 
supplied onto the condenser at the 
back of the appliance by rotating them 
1/4 turn.

5. The appliance should be located on 
a smooth surface. 
The two front feet can be adjusted as 
required. 
To ensure that,your appliance is 
standing upright adjust the two front 
feet by turning clockwise or anti-
clockwise, until the product is in 
firm contact with the floor. Correct 
adjustment of feet avoids excessive 
vibration and noise.
6. Refer to “Cleaning and Care” 
section to prepare your appliance for 
use.
7.A special receptacle is supplied to 
store the mains plug during transit. 
The receptacle is fixed at the back of 
the cabinet, on the right hand side of 
the compressor. (See diagram) Gently 
remove the plug from the receptacle. 
Never pull the mains cord, you may 
damage the appliance. In the case 
of transportation, ensure you locate 
the plug in the receptacle provided to 
avoid transit damage. transit 
provided to avoid transit damage.