3M 78-8135-4385-3-A User Manual

 

24

 

78-8135-4385-3-A

19.8  Leaving polishing jig assembly positioned on the 

lapping film rotate 180 degrees. Perform 4 additional 

figure eights.

19.9  Once polishing is complete , refer to steps 17.14 

through 17.17 on inspecting the connector with the 

200X fiber view scope before proceeding to final step. 

20.1  If connector is not to be immediately put into service, 

install the protective dust cap.

21.1  Duplex yokes may be mounted after connector has 

been terminated.

21.2  With the anti-snag clip facing connector press cable 

into slot on the duplex yoke and then slide the yoke up 

and over the boot.