Stamina Products 55-1510 User Manual

1.  To store the 

inLine® Inversion System, simply keep it in a clean dry place.

2.   Move the 

inLine® Inversion System by lifting the frame and moving slowly.

 

NOTE: Two people are required to move the inLine® Inversion System.

The safety and integrity designed into the 

inLine® Inversion System can only be maintained when the 

inLine® Inversion System is regularly examined for damage and wear. Special attention should be 

given to the following:

1.  Check the pivot arms, cushions, foam pads, and foam pads adjustment device for damage and wear.

2.  Verify  that  all  nuts  and  bolts  are  present  and  properly  tightened.  Replace  missing  nuts  and  bolts. 

Tighten loose nuts and bolts.

3.  Verify that the 

WARNING LABEL(50) is in place and easy to read. Call Stamina Products immediately 

at 

1-800-375-7520 for a replacement WARNING LABEL(50) if it is missing or damaged.

4.  It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.

5.  Worn  or  damaged  components  shall  be  replaced  immediately  or  the 

inLine® Inversion System 

removed from service until repair is made.

6.  Only Stamina Products supplied components shall be used to maintain/repair the 

7.  Keep your 

inLine® Inversion System clean by wiping it off with an absorbent cloth after use.