Stamina Products 55-1510 User Manual
6
length
length
mm.
in.
INCHES
This chart is provided to help identify the hardware used in the assembly process. Place the washers or
the ends of the bolts or screws on the circles to check for the correct diameter. Use the small scale to
check the length of the bolts and screws.
NOTICE: The length of all bolts and screws, except those with flat
heads, is measured from below the head to the end of the bolt
or screw. Flat head bolts and screws are measured from the
top of the head to the end of the bolt or screw.
After unpacking the unit, open the hardware bag and make sure that you have all the following items.
Some hardware may be already attached to the part.
MILLIMETERS
0
10 20 30 40 50 60 70 80 90 100 110 120 130 140 150
0
1/2
1
1/2
2
1/2
3
1/2
4
1/2
5
1/2
6
6
8
10
12
3/16"
1/4"
5/16"
3/8"
1/2"
HARDWARE IDENTIFICATION CHART
44
Washer (M8)
2
48
Washer (M12)
4
Part Number and Description
Qty
49
Bolt, Round Head (M6 x 1 x 15mm)
8
39
Bolt, Button Head (M8 x 1.25 x 15mm)
8
40
Bolt, Button Head (M6 x 1 x 15mm)
4
45
Arc Washer (M6)
4
47
Arc Washer (M8)
2
34
Bolt, Button Head (M12 x 1.75 x 95mm) 2
35
Bolt, Button Head (M12 x 1.75 x 85mm) 2