Adtran TSU IQ+ User Manual
Chapter 2. Installation
2-2
TSU IQ+ User Manual
61200275L1-1
The following items are included in ADTRAN shipments of DBU
cards:
cards:
•
DBU card
•
An 8-position modular to 8-position modular cable for the
4-wire SW56, ISDN, or PRI DBU options or an 8-position
modular to 4-position modular cable for the V.34 DBU option
4-wire SW56, ISDN, or PRI DBU options or an 8-position
modular to 4-position modular cable for the V.34 DBU option
Customer Provides
The customer must provide a male V.35 interface cable.
For SNMP management not accessed through the
V.35
or
Network
port, the customer must provide access to the TSU IQ+ either
through a SLIP, Async PPP (requires a male 25-pin D-type
connector), or a through the
through a SLIP, Async PPP (requires a male 25-pin D-type
connector), or a through the
10BaseT Ethernet
port (requires that an
ADTRAN Ethernet card be installed in the TSU IQ+). See Pinouts
on page A-1 for the pin assignments of the
on page A-1 for the pin assignments of the
C
ONTROL
port (for SLIP
and Async PPP) and the
E
THERNET
port.
Power Up
The TSU IQ+ is provided with a captive 8-foot power cord,
terminated by a three-prong plug which connects to a grounded
115 VAC power receptacle.
terminated by a three-prong plug which connects to a grounded
115 VAC power receptacle.
REAR PANEL
The rear panel contains a DTE connector which provides primary
channel
channel
V.35
. An 8-pin Network jack, Test Jacks, a DSX-1 port, a
Control port, a captive power cord, and a power switch are also
located on the rear panel. Pin assignments for these connectors are
located on the rear panel. Pin assignments for these connectors are
Power to the TSU must be provided from a grounded 115 VAC, 60 Hz re-
ceptacle.
ceptacle.