DISH Network 6.2 User Manual

You can program your remote control in Limited Mode to keep from 
accidentally changing the channel on your TV or VCR. When you use 
the remote to control your TV in Limited Mode, you will only be able 
to use the POWER, MUTE, and VOLUME buttons to control your TV. 
Also, when you use the remote to control your VCR in Limited Mode, 
you will only be able to use the POWER and VCR function buttons. 
The section Programming Using the Equipment Code Tables has a step 
that tells the remote control to go into Limited Mode. Also, a quick 
way to put the remote in Limited Mode is on page C-6. 

Note: Limited Mode can not be used with audio amplifiers.

You can set up the remote to control other equipment using the 
equipment codes listed on page 12 and the modes as shown on page 2. 

1

Turn the equipment on.

Use the equipment’s front panel 
buttons or its remote control.

2

Find the brand name of the 

equipment in the tables 
starting on page 12. 

If the brand isn’t listed, see 
Scanning for Equipment Codes 
on page 4.

3

Press and hold the mode 

button until all the other 
mode buttons light up, and 
then let go of the button. 
The mode button flashes.

For example, hold the TV mode 
button for a TV until all of the 
other mode buttons light. When 
you let go, TV will flash.

4

For AUX mode only. Press 

0 for a second TV, or 1 for a 
second VCR, or 2 for a 
tuner, or amplifier.

This step is for programming 
the kind of equipment that 
should be programmed in AUX 
mode. If you’re not 
programming in AUX mode, 
skip to step 5.

5

Enter one of the three-digit 

equipment codes from the 
table using the number 
buttons. 

The three-digit equipment code 
should be for the brand name of 
your equipment that you found 
in step 2.

62book.book  Page 3  Tuesday, April 4, 2006  1:45 PM