Sunwave Tech. 3815 User Manual
SRC-38 SERIES User’s Manual
52
One or more devices
do not respond in RF
do not respond in RF
mode.
When operating properly, the red LED
light on the front of the IR-extender will
light on the front of the IR-extender will
blink while sending or receiving signals. To
test IR-extender:
1. Press Remote Locator button.
2. Use remote in RF mode.
LED should blink during each test.
RF addresses for device(s) and IR-
1. Press Remote Locator button.
2. Use remote in RF mode.
LED should blink during each test.
RF addresses for device(s) and IR-
extender may not set to the same
setting. Check setting on each and reset
setting. Check setting on each and reset
of needed.
Check to make sure SRC-3815 is set to
Check to make sure SRC-3815 is set to
operate in RF mode.
IR-extender is not aimed at desired
IR-extender is not aimed at desired
device. Reposition IR-extender.
No AC power to IR-extender. Make sure
No AC power to IR-extender. Make sure
AC adapter is plugged in.
Batteries may be low in remote. Change
Batteries may be low in remote. Change
batteries if needed.