Razor 13010400 User Manual

3

Note: The joint lever is spring-

loaded and will automatically lock 

in the upright position when fully 

upright.

 Depress the spring loaded button on the T-bar and insert into the 

extension tube. Turn the T-bar until the button aligns with the hole on the

extension tube and locks into place. To adjust the height of the handlebars,

open the quick-release lever and slide the T-bar to the desired position and 

resecure the quick release lever to lock into place. If the T-bar is raised to the 

maximum height, depress the spring loaded button located directly below the

quick release lever to lower the T-bar.  

Note: The tension of the quick-

release lever can be adjusted by 

tightening or loosening the allen 

bolt. Be careful not to over-tighten. 

You should always be able to open 

and close the quick-release lever by 

hand.

       WaRNINg: Failure to 

properly secure the quick-release 

lever may cause the T-bar to slideup 

or down while riding which may 

cause you to lose control and fall. 

       WaRNINg: Failure to 

properly secure the spring-loaded 

buttons may cause the handlebars 

to dislodge while riding and may 

cause you to lose control and/or 

fall. When properly secured, the 

handlebars will not rotate and/

or move sideways. Note: When 

properly secured, the spring-loaded 

buttons will be clearly visible 

through the holes on the T-tube.

 Make certain 

BOTH handlebars 

are properly locked onto the T-bar. 

 Insert and secure the left and 

right handlebars by depressing 

the spring-loaded buttons and  

inserting them into the T-bar.

 To release the folding  

mechanism, place one foot on the 

deck plate and push joint release 

lever down to release the T-bar/

Extension Tube from the locked po-

sition. Raise T-bar up until securely 

locked in the upright position. 

       WaRNINg: Keep 

your fingers clear of the folding 

mechanism when folding or

unfolding the scooter. Make sure 

others are standing clear.

q