Precor EFX532i User Manual
C846i/C842i Recumbent Cycle Assembly Guide
3
Assembly Steps
Position the rubber bib (E) so the flared side faces the floor (as shown
in the illustration) and slide it into the base of the upright support.
in the illustration) and slide it into the base of the upright support.
Place the upright support on the base crossbar so that the lip of the
rubber bib rests on the crossbar and is parallel to the floor.
rubber bib rests on the crossbar and is parallel to the floor.
Have your assistant hold the upright support while you connect the two
cables. Place excess cable inside the base assembly.
cables. Place excess cable inside the base assembly.
Note: The C842i has only one cable connection.
Important: Do not stretch, crimp, or damage the cables. Cables
damaged by improper installation will not be covered by the Precor
Limited Warranty.
damaged by improper installation will not be covered by the Precor
Limited Warranty.
CAUTION: Before tightening the screws, make sure the cables
are not in danger of being crimped or pinched.
are not in danger of being crimped or pinched.
Secure the upright support to the base assembly using two hex head
cap screws (A) and two washers (B). Alternately tighten each screw
using a
cap screws (A) and two washers (B). Alternately tighten each screw
using a
³⁄₄-inch box-end or crescent wrench. Check the upright support
to make sure it is securely fastened.