3M 2250M-iD User Manual

78-8130-6150-0 Rev G

D. Enabling/Disabling Frequencies

MENU [6] + >>More [SK:4] + Setup [SK:6] + >>More [SK:6d] + Locate Freq [SK:6g]

The user can select the frequencies that the receiver will detect. All the available

frequencies are listed in four groups (Left to Right: Active, Power, Passive, and

Auxiliary). The Auxiliary group also contains the User Defined Frequencies. (See

Creating User Defined Frequencies, Section 5F.)

1. Press the right arrow [SK] to move the highlight

bar to the section of frequencies to enable, or

disable.

2. Press the up/down arrows [SK] to highlight the

specific frequency.

3. Press Enabl/Disabl [SK]. (Enable denoted by )
4. Repeat steps 2 & 3 to enable/disable other

frequencies.

5. Press Locate/OK [5] to save.

E. Selecting External Jack [14] ([13] on 2250M locator) Frequencies
(Tone Frequencies)

MENU [6] + >>More [SK:4] + Setup [SK:6] + >>More [SK:6d] + Tone Freq [SK:6j]

A coupler can be plugged into the External Jack [14]

([13]) on 2250M locator) of the receiver and used to

identify cables. (See Additional Applications: Cable

Identification, Section 19B.) The same procedure

as D. Enabling/Disabling Frequencies (above)

is followed for selecting frequencies that can be

detected by the External Jack [14] ([13]) on 2250M

locator) found on the bottom of the receiver.

F. Creating User Defined Frequencies

MENU [6] + >>More [SK:4] + Setup [SK:6] + >>More [SK:6d] + Locate Freq [SK:6g]

There are four user defined frequencies available on the receiver. (These frequencies

must be between 50 Hz and 999 Hz.) These frequencies are found in the column on the

far right of the Locate Freq display (Auxiliary frequencies). These frequencies, once

programmed, will appear in the Locate mode under the Aux [SK] frequency list when

Freq [SK] is selected in the Locate mode.