Apple BV9150 User Manual

E - 4

a.  Make sure your car battery is a 12 volt (6 filler caps) negative ground system (if not, a 

converter will be necessary).

b. 

 

Before starting wiring connections, disconnect the power supply by removing the fuse from 

the fuse box.

c.  Connect the power wire to one of the extra terminals of the fuse box.
d.

  

Connect the black ground wire to a metal part of the car. It is important to make good 

contact.

e.  Make other wiring connections as shown. 
f.   If your car does not have ISO connector, you can purchase it from car accessory shops.

Fuse Replacement:
To replace the fuse, pull out the blown fuse
from the socket. Insert a new one with same 
rating

The RESET button is located on the main unit (as shown on the diagram). To press it vertically 
with a ballpoint pen or metal object to activate it. The reset button should be activated for the 
following reasons:

Initial installation of the unit when all wiring is completed.
All the function buttons do not operate.
Error symbol on the display.

Note: If you press the RESET button, and the unit still cannot function normally, please use a 
cotton swab soaked in isopropyl alcohol to clean the socket on the back of the control panel.