Sunfire HRS-SAT4 User Manual

User's Manual

5

1.  Mounting Brackets

The satellite loudspeaker has one 

keyhole bracket that allows for wall 

mounting and fitting onto the optional 

stand.

The center channel loudspeaker has 

two keyhole brackets, and can be 

mounted horizontally or vertically. 

.  Binding Posts

The loudspeakers each have a pair of 

5-way binding posts, that accept bare 

wire, pin connectors, spade connec-

tors, banana and dual-banana plugs*.

Always use high quality connections 

and speaker wires, and make sure 

there are no loose fittings or stray wire 

strands.

Connect the positive speaker-level 

output of your power amplifier or 

receiver to the positive (red) input of 

the loudspeaker. Connect the negative 

speaker-level output of your power am-

plifier or receiver to the negative (black) 

input of the loudspeaker.

Make sure that the positive and nega-

tive connections do not touch, or this 

may damage your power amplifier.

*Note that the banana and dual-banana 

plugs will not work if the loudspeakers 

are wall-mounted, or if the HRS-SAT4 

is fitted on the optional stand.

3.  Anti-vibration pads

These pads can be fixed to the bottom 

of the loudspeakers if they are not wall 

mounted, and can be fixed to the rear 

panel if they are wall-mounted. They 

can also be fitted along the bottom 

edge of the HRS-SAT4C to allow it to 

tilt further up if required (see below).

To stand the center speaker vertically 

on a shelf, use the pads on the rear of 

the touching face to allow the speaker 

to stand vertically (or they will tilt back).

4.  Kickstand 

This supports the rear 

of the HRS-SAT4C, and 

allows it to tilt up or down. 

Tighten the knurled nut 

when you have found the 

best position. 

If you are wall-mounting 

the loudspeaker, then the 

kickstand and nut must 

be removed. Keep them 

in a safe place.

5.  Grille

The grilles are attached with magnets. 

To remove them, gently pry away from 

the corners. The magnetic logo badge 

on the HRS-SAT4C fits either vertically 

or horizontally in shallow recesses   

in the grille, depending on how  

 

you are using the loudspeaker.

Features

HRS-SAT4

HRS-SAT4C

1

 1

1

4

3

3

3

Tilt down

Flat

Tilt up

Tilt up more 

with pads