Jensen JiSS-100 User Manual
9
SPECIFICATIONS
Power requirement ………………....…… AC 120V ~ 60Hz 15 W
DC 6V, “AA” (UM-3) X 4
Frequency Range………...………......….. AM 530 - 1710 kHz
FM 87.5 - 108 MHz
Power output …………………….......……1.5W x 2
Speaker loading………………….....……. 8 Ohm x 2
iPod is a trademark of Apple Inc., registered in the U.S. and other countries.
"Made for iPod" means that an electronic accessory has been designed to connect specifically to iPod
"Made for iPod" means that an electronic accessory has been designed to connect specifically to iPod
and has been certified by the developer to meet Apple performance standards.
Apple is not responsible for the operation of this devise or its compliance with safety and regulatory
Apple is not responsible for the operation of this devise or its compliance with safety and regulatory
standards.
TROUBLESHOOTING GUIDE
If you experience difficulties in the use of this Docking System, please check the following or call
1-800-777-5331 for Customer Service.
1-800-777-5331 for Customer Service.
n
o
i
t
u
l
o
S
e
s
u
a
C
e
l
b
i
s
s
o
P
m
o
t
p
m
y
S
The unit does not
respond (no power)
respond (no power)
AC cord is not plugged properly into a
wall outlet or the connector is not
plugged into the AC IN jack on the
back of the unit.
plugged into the AC IN jack on the
back of the unit.
Wall outlet is not functioning.
Plug the AC cord into a wall outlet and plug
the connector into the AC IN jack on the
unit.
the connector into the AC IN jack on the
unit.
Plug another device into the same out
outlet to confirm the outlet is working.
outlet to confirm the outlet is working.
iPod cannot not be
docked properly.
docked properly.
Using wrong iPod Adaptor.
Make sure the dock insert is properly fit for
your iPod.
Make sure the dock insert is properly fit for
your iPod
Remove your iPod from the dock and
check for obstruction on the connectors in
the dock and on your iPod. Then reseat it in
the dock.
your iPod.
Make sure the dock insert is properly fit for
your iPod
Remove your iPod from the dock and
check for obstruction on the connectors in
the dock and on your iPod. Then reseat it in
the dock.
iPod does not respond
to the system
to the system
iPod is not installed properly.
Your iPod is locked up.
Remove your iPod from the dock and
check for obstruction on the connectors in
the dock and on your iPod. Then reseat it
on the dock.
check for obstruction on the connectors in
the dock and on your iPod. Then reseat it
on the dock.
Please make sure that your iPod is working
properly before docking into the unit.
Please refer to your iPod manual for info on
resetting the iPod.
properly before docking into the unit.
Please refer to your iPod manual for info on
resetting the iPod.
iPod does not charge up
iPod is not installed properly.
iPod is locked up/ frozen.
iPod battery has problem.
Remove your iPod from the dock and
check for obstruction on the connectors in
the dock and on your iPod. Then reseat it in
the dock.
check for obstruction on the connectors in
the dock and on your iPod. Then reseat it in
the dock.
Please make sure your iPod is working
properly before docking into the unit.
Please refer to your iPod manual for details
on resetting.
properly before docking into the unit.
Please refer to your iPod manual for details
on resetting.
AM band is too noisy.
The reception at the set location is
poor
poor
Interference from the iPod
Slightly rotate the AM loop antenna position
for the best reception.
Move the AM loop antenna away from the
unit to avoid interference.
Undock the iPod
for the best reception.
Move the AM loop antenna away from the
unit to avoid interference.
Undock the iPod
FM band is too noisy.
The reception at the set location is
poor
poor
Interference from the iPod
Make sure the FM Antenna is fully
extended and tape it onto the wall if
required, the higher the better
Undock the iPod
extended and tape it onto the wall if
required, the higher the better
Undock the iPod