GPX CC319B Leaflet

Page of 2
CUSTOMER HELPLINE  |  1-314-621-2881 
GPX  |  CC319B
WARNINGS & PRECAUTIONS
FCC WARNINGS
IMPORTANT SAFETY INSTRUCTIONS
INTRODUCTION
USER’S GUIDE
V:1615-0520-09
CC319B
CD Clock Radio with Dual Alarms
•  CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE 
BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
•  WARNING: To prevent fire or shock hazards, do not expose this unit to
rain or moisture.
•  CAUTION: Use of controls or adjustments or performance of procedures 
other than those specified may result in hazardous radiation exposure.
•  WARNING: Changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user’s authority to
operate the equipment.
•  WARNING: Do not place the unit on top of any soft, porous, or sensitive
surfaces to avoid damaging the surface. Use a protective barrier between 
the unit and surface to protect the surface.
•  CAUTION:  Danger of explosion if battery is incorrectly replaced. Re-
place only with the same or equivalent type.
•  PRÉCAUTION: Danger d’explosion si les piles sont remplacées de fa-
çon incorrect. Remplacer les piles seulement par le même type de pile ou 
l’équivalent.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-
mh, etc) batteries.
No mezcle baterías viejas y nuevas.
No mezcle baterías alcalinas, estándar (carbono-zinc) o recargables (ni-
cad, ni-mh, etc.).
1.  Read these Instructions.
2.  Keep these Instructions.
3.  Heed all Warnings.
4.  Follow all instructions.
5.  Do not use this apparatus near water.
6.  Clean only with a dry cloth.
7.  Do not block any ventilation openings. Install in accordance with the
manufacturer’s instructions.
8.  Do not install near any heat sources such as radiators, heat registers,
stoves, or other apparatus (including amplifiers) that produce heat.
9.  Do not defeat the safety purpose of the polarized or grounding - type
plug. A polarized plug has two blades with one wider than the other. A
grounding type plug has two blades and a third grounding prong. The
wide blade or the third prong are provided for your safety. When the
provided plug does not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.
10. Protect the power cord from being walked on or pinched particularly at
plugs, convenience receptacles, and the point where they exit from the
apparatus.
11. Only use attachments/accessories specified by the manufacturer.
12.Use only with a cart, stand, tripod,
bracket, or table specified by the
manufacturer, or sold with the 
apparatus. When a cart is used, 
use caution when moving the cart/
apparatus combination to avoid 
injury from tip-over.
13. Unplug this apparatus during lightning storms or when unused for long 
periods of time.
14. Refer all servicing to qualified service personnel. Servicing is required
when the apparatus has been damaged in any way, such as power-supply
cord or plug is damaged, liquid has been spilled or objects have fallen into 
the apparatus, the apparatus has been exposed to rain or moisture, does
not operate normally, or has been dropped.
The exclamation point within an equilateral triangle
is intended to alert the user to the presence of 
important operating and maintenance (servicing)
instructions in the literature accompanying the
appliance.
The lightning flash with arrowhead symbol, within
an equilateral triangle, is intended to alert the user 
to the presence of uninsulated "dangerous voltage" 
within the product's enclosure that may be of
sufficient magnitude to constitute a risk of electric
shock to persons.
WARNING: TO REDUCE THE RISK OF 
ELECTRIC SHOCK, DO NOT REMOVE COVER 
(OR BACK). NO USER-SERVICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED 
SERVICE PERSONNEL.
CD Door
Open and close to load or 
unload a CD.
AL1 (Alarm 1)
Press to view and set alarm 1.
AL2 (Alarm 2)
Press to view and set alarm 2.
Sleep
Press to set the sleep timer.
Snooze
Press to delay the alarm for an
additional 9 minutes after it has 
sounded.
CLK Set
Press to adjust the hour and 
minute when setting the clock 
or alarms.
Dimmer
Use to adjust the brightness of 
the display.
Tuning
Turn to adjust the AM or FM 
radio frequency.
Buzz/Radio/CD
Use to adjust the source to 
Radio or CD, or to adjust the 
alarm source to Buzzer, Radio,
or CD.
Volume
Turn to adjust the volume.
AM/FM ST.
Use to adjust the radio mode to 
AM or FM.
Backup Battery 
Compartment
Requires one 9 volt battery (not
included).
Power
Press to turn the unit off and on.
Random/CLK ADJ
With the clock radio powered 
off, press to set the clock.
In CD mode, press to play
tracks from the loaded CD in a 
random order.
Play/Pause
Press to play or pause the
loaded CD.
Skip/Search
Press to Skip to the previous or 
next track.
Press and hold to rewind or 
fast-forward within a single 
track.
Stop
Press to stop the CD.
Repeat
Press to repeat the current track.
The Repeat Indicator Light will 
blink when the clock radio is set 
to repeat a single track.
While set to repeat a single 
track, press to repeat the entire 
CD.
The Repeat Indicator Light 
will illuminate solid when the 
clock radio is set to repeat the 
entire CD.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These 
limits are designed to provide reasonable protection against harmful inter-
ference in a residential installation. This equipment generates, uses, and can 
radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not occur in a 
particular installation. If this equipment does cause harmful interference to 
radio or television reception, which can be determined by turning the equip-
ment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
•  Reorient or relocate the receiving antenna.
•  Increase the separation between the equipment and receiver.
•  Connect the equipment into an outlet on a circuit different from that to 
which the receiver is connected.
•  Consult the dealer or an experienced radio/TV technician for help.