Alliance Laundry Systems LES33A User Manual
504607
17
Location Requirements . . .
Select a location with a solid floor.
No other fuel burning appliance should be installed in
the same closet with the dryer.
the same closet with the dryer.
The dryer must not be installed or stored in an area
where it will be exposed to water and/or weather.
where it will be exposed to water and/or weather.
Leveling legs can be adjusted from inside the dryer
with a 1/4" driver. All four legs must rest firmly on the
with a 1/4" driver. All four legs must rest firmly on the
floor so the weight of the dryer is evenly distributed.
The dryer must not rock.
The dryer must not rock.
The dryer needs sufficient clearance and an adequate
air supply for proper operation and ventilation, and for
easier installation and servicing. (Minimum clearances
are shown below.)
air supply for proper operation and ventilation, and for
easier installation and servicing. (Minimum clearances
are shown below.)
CLOSET
DOOR
D317IE3C
FRONT VIEW
(w/o Closet Door)
SIDE VIEW
A
A
C
A
D
E
B
CENTERED
AIR
OPENINGS (G)
(2 Openings
Minimum)
FRONT VIEW
(Closet Door)
F
F
OUTER
WALL OF
ENCLOSURE
**42"
** NOTE: For new installations, locate top of wall vent 42 inches above floor to make venting easier to
connect.
AREA
DESCRIPTION
FREE STANDING / ALCOVE
INSTALLATION
(See Illustration)
INSTALLATION
(See Illustration)
CLOSET INSTALLATION
(See Illustration)
(See Illustration)
A
Dryer sides and rear clearance
0" (0 cm)
0" (0 cm)
B
Dryer top clearance
12" (30.5 cm)
12" (30.5 cm)
C
Dryer front clearance
Not Applicable
2" (5.1 cm)
D
Exhaust duct clearance to
combustible material
combustible material
2" (5.1 cm)
2" (5.1 cm)
E
Weather hood to ground clearance
12" (30.5 cm)
12" (30.5 cm)
F
Distance from floor or ceiling to
hole edge
hole edge
Not Applicable
3" (7.6 cm)
G*
Area of centered air openings in
closet door
closet door
Not Applicable
40 sq. in./open (260 sq. cm)
*Louvered door with equivalent air openings is acceptable. (Minimum clearances are shown.)