Alliance Laundry Systems 25 User Manual

70400201

14

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

The Diagnostic Microprocessor Control (DMP) is 
designed to manage the drying and cooling cycles of 
the tumbler. The controller is also programmed from 
the factory with five different default programs as 
described below. The operator has the flexibility to 
select the time for the drying and the cool down cycles 
and the drying temperature. The operator may also 
select either reversing or nonreversing basket action 
only if the tumbler is equipped for reversing. The 
operator may also reprogram the default programs. 
See Programming. 

●

Drying time: 0-60 minutes

●

Cooling time: 2-60 minutes

●

LED display of cycle time, set temperature, and 
actual    temperature

●

Thermistor controlled temperature

●

Safety tumble cycle 

●

Buzzer for end of cycle, audible alarm

●

Reversing/Nonreversing selection

●

Five user programmable programs

●

RPM display – when equipped with rotational 
   sensor only

●

Monitors the lint door switch operation

●

Monitors the thermistor for operation

The minimum drying time is 0 minutes, and the 
minimum cooling time is 2 minutes. The maximum 
drying or cooling time is 60 minutes. The drying 
temperature may be set from 100ºF (38ºC) to 185º/
195ºF (85º/91ºC). The drying time, cooling time, or 
temperature may be modified during an operating 
cycle.

If it is necessary to reset the drying and cooling times 
for the current cycle, press STOP once to stop the 
tumbler. Press STOP again to cancel the cycle. 

If it is necessary to change programs during a current 
cycle, press STOP once to stop the tumbler and press 
STOP again to cancel the current cycle. 

40

5 

185º/195ºF
 (85º/91ºC)

No

30

5

165ºF (74ºC)

Yes

30

5

150ºF (66ºC) 

No

25

5

135ºF (57ºC)

Yes

5

2

150ºF (66ºC)

No

Table 1