Alliance Laundry Systems T433I User Manual
Adjustments
M414038
52
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
CE Marked Models
The loading door switch is factory adjusted to turn
off tumbler when the door is opened a maximum
of 3 inches (76.2 mm). If adjustment is needed, refer to
Figure 24 and follow these steps.
off tumbler when the door is opened a maximum
of 3 inches (76.2 mm). If adjustment is needed, refer to
Figure 24 and follow these steps.
1. Start tumbler, following the operating
instructions which accompanied it.
2. Slowly open loading door. Cylinder and heating
system should stop when door is open 3 inches
(76.2 mm) maximum.
(76.2 mm) maximum.
3. Slowly close loading door while depressing start
switch or pad. Tumbler should start before
loading door is 0.5 inch (13 mm) from fully
closed.
loading door is 0.5 inch (13 mm) from fully
closed.
4. If opening the loading door 3 inches (76.2 mm)
maximum does not stop tumbler, adjust switch.
a. Loosen lower screw on switch coupler (use
2 mm hex wrench).
b. Align screw slot with alignment marks on
switch top (switch should be closed, or on).
c. Start tumbler.
d. Prop door open 2.5 inches (63.5 mm).
e. Slowly rotate switch coupler
counterclockwise (viewed from above switch)
until tumbler stops.
until tumbler stops.
f. Tighten lower screw on switch coupler.
g. Return to step 1 to verify loading door switch
operation.
Figure 24
T495I
1
Loading Door Switch
2
Screw Slot
3
Switch Coupler
3
1
2