Alliance Laundry Systems 602004144 User Manual

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

70400101 (EN)

22

1. Remove lint and debris from inside exhaust duct 

to maintain proper airflow and avoid 

overheating.

a. Remove external duct and duct access covers, 

if present.

b. Clean inside of duct with a vacuum.

c. Clean dampers and make sure they operate 

freely.

d. Replace duct and all access covers before 

returning tumble dryer to operation.

2. Ensure even lint distribution over lint screen, 

replace if distribution of lint is uneven to 

maintain proper airflow and avoid overheating.

3. Carefully wipe any accumulated lint off the 

cabinet high limit thermostat and thermistor, 

including perforated cover. Lint buildup will act 

as an insulator, causing machine to overheat.

4. Clean lint and debris buildup from blower to 

maintain proper airflow, avoid overheating and 

prevent possible vibration.

1. Use a vacuum to clean air vents on drive motors.
2. Use a vacuum to clean lint from rear limit 

thermostat cover.

3. Check and clean steam coils, if applicable.
4. Check flow of combustion and ventilation air.
5. Check belt tension and condition. Replace worn 

or cracked belts.

1. Check mounting hardware for any loose nuts, 

bolts or screws.

2. Check gas connections for leakage.
3. Check for loose electrical connections.
4. Check steam connections for looseness and 

leakage.

5. Remove all front panels and vacuum, including 

coin drop mechanisms.

6. Check cylinder and front panel seals.
7. Inspect cabinet and inner panels for any damage, 

replace or repair as needed.

8. Clean burner tubes and orifice area of any lint 

buildup.

1. Remove cylinder. Use a vacuum to clean lint 

from area around rear seal and idler assembly. 

Check seal idler assembly for wear.

2. Remove burner tubes and clean using water and a 

brush.

W002R1