Alliance Laundry Systems 250 C.F.M. User Manual
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
54
M414545
ELECTRONICALLY CONTROLLED OPL TUMBLER
INTRODUCTION
Drying can be done automatically or by time dry. When
drying automatically, the tumbler stops drying when
laundry reaches the factory set or programmed dryness
level and starts cool down. When time drying, the
tumbler stops drying when programmed time ends and
starts cool-down.
drying automatically, the tumbler stops drying when
laundry reaches the factory set or programmed dryness
level and starts cool down. When time drying, the
tumbler stops drying when programmed time ends and
starts cool-down.
Special Cycle allows user to specify the number of
heating cycles and specify temperature from 80°F (27°C)
to 180°F (82°C) for all heat cycles.
heating cycles and specify temperature from 80°F (27°C)
to 180°F (82°C) for all heat cycles.
Special Time allows user to specify temperature from
80°F (27°C) to 180°F (82°C) for all heat cycles.
80°F (27°C) to 180°F (82°C) for all heat cycles.
Both automatic and time dry have factory-set cycles, but
other cycles can also be created. Frequently used cycles
can be saved in the control's memory as Custom cycles.
Refer to Figure 25.
other cycles can also be created. Frequently used cycles
can be saved in the control's memory as Custom cycles.
Refer to Figure 25.
A drying instructions chart is included for recording
selections and settings for various load types. Refer to
Figure 31.
selections and settings for various load types. Refer to
Figure 31.
In all cycles, except No Heat, Wrinkle-Free begins when
Cool Down ends. During Wrinkle-Free, the tumbler
alternately stops for 2-1/2 minutes and then runs without
heat for 2-1/2 minutes until door is opened or 60 minutes
has elapsed.
Cool Down ends. During Wrinkle-Free, the tumbler
alternately stops for 2-1/2 minutes and then runs without
heat for 2-1/2 minutes until door is opened or 60 minutes
has elapsed.
All pads can be pressed in any sequence without
damaging control or tumbler. To stop the tumbler at any
time, open the door or press STOP/RESET. The window
display will flash. Press STOP/RESET twice (within 3
seconds) to end the cycle and reset the control to idle
status. Refer to Figure 24.
damaging control or tumbler. To stop the tumbler at any
time, open the door or press STOP/RESET. The window
display will flash. Press STOP/RESET twice (within 3
seconds) to end the cycle and reset the control to idle
status. Refer to Figure 24.
NOTE: Not all tumblers will have reversing option.
OPL Micro Control Panel
Figure 24