Alliance Laundry Systems DRY710C User Manual

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

513005

30

CLEAN THE LINT FILTER BEFORE DRYING 

EACH LOAD. (Refer to Figure 42 for lint filter 

location.) Cleaning the lint filter is important because 

a layer or pad of lint on the filter will block the flow of 

air through the dryer, thus reducing the efficiency of 

the dryer. The clothes will take longer to dry and 

energy will be wasted.
The lint filter may be washed if needed. Annually 

remove lint filter and screw to vacuum the duct under 

it.

Figure 42 

The dryer’s motor overload protector stops the motor 

automatically in the event of an overload. After 

cooling, the overload protector will reset itself. Dryer 

can be restarted by pressing the START pad. If 

overload protector cycles again, remove the dryer 

from use and call the service person to correct the 

problem.

 Make sure the lint filter is always clean.
 Do not overload dryer.
 Do not overdry clothes.
 Remove items to be ironed while still damp.
 Large loads of similar fabrics dry the most 

efficiently. However, dry permanent press in 

smaller loads to prevent wrinkling.

 Use the correct temperature FABRIC 

SELECTOR setting for the type of fabric being 

dried.

 Locate your dryer so the exhaust duct is as short 

and straight as possible.

 Do not open the door during the drying cycle.
 Plan to do your laundry on low humidity days; 

your clothes will dry faster.

 Should you plan to dry several loads, do them 

one after another, then you do not have to reheat 

the dryer unit’s interior parts each time.

D608I

Lint Filter

D608I