JVC LYT1265-001B User Manual

MasterPage: Video_Right

In some situations, different 
shooting angles may provide 
more dramatic results. Hold the 
camcorder in the desired position 
and tilt the LCD monitor in the 
most convenient direction. It can 
rotate 270° (90° downward, 180° 
upward).

Open the LCD monitor and tilt 
it upward to 180° so that it 
faces forward, then point the 
lens toward yourself and start 
recording.

During recording, a time code is recorded on the tape. 
This code is to confirm the location of the recorded scene 
on the tape during playback. 

* Frames are not displayed during recording.

If recording starts from a blank portion, the time code 
begins counting from “00:00:00” (minute:second:frame). 
If recording starts from the end of a previously recorded 
scene, the time code continues from the last time code 
number.
If during recording a blank portion is left partway through 
the tape, the time code is interrupted. When recording is 
resumed, the time code starts counting up again from 
“00:00:00”. This means the camcorder may record the 
same time codes as those existing in a previously 
recorded scene. To prevent this, perform “Recording 
From The Middle Of A Tape” (See the right column) in the 
following cases;

● When shooting again after playing back a recorded tape.

● When power shuts off during shooting. 

● When a tape is removed and re-inserted during shooting.

● When shooting using a partially recorded tape. 

● When shooting on a blank portion located partway through 

the tape.

● When shooting again after shooting a scene then opening/

closing the cassette holder cover.

1) Play back a tape or use Blank Search (

墌 pg. 14) to 

find the spot at which you want to start recording, then 
engage the Still Playback mode. (

2) Set the Power Switch to “A” or “M” while pressing 
down the Lock Button located on the switch, then start 
recording.

● The time code cannot be reset.

● During fast-forwarding and rewinding, the time code 

indication does not move smoothly.

● The time code is displayed only when “TIME CODE” is set 

to “ON”. (

GR-D94US.book  Page 13  Monday, November 17, 2003  2:12 PM