JVC LYT1265-001B User Manual

MasterPage: Advan_Right

It is also possible to copy recorded scenes from the 
camcorder onto another video unit equipped with a DV 
connector. Since a digital signal is sent, there is little if 
any image or sound deterioration. 

Make sure all units are turned off.

Connect this camcorder to a video unit equipped with 

a DV input connector using a DV cable as shown in the 
illustration.

Set this camcorder’s VIDEO/MEMORY Switch to 

“VIDEO”.

Set this camcorder’s Power Switch to “PLAY” while 

pressing down the Lock Button located on the switch.

Turn on the video unit’s power.

Insert the source cassette in this camcorder.

Insert the recording cassette in the video unit.

Press 4/9 on this camcorder to start playback of the 

source cassette.

At the point you want to start dubbing, engage the 

video unit’s Record mode.

To pause dubbing, engage the video unit’s Record-

Pause mode and press 4/9 on this camcorder.

Repeat steps 

8 – 10 for additional editing. Stop the 

video unit and camcorder.

● It is recommended to use the AC Adapter as the power 

● If the remote control is used when both the player and 

recorder are JVC video units, both units will perform the 
same operation. To prevent this from happening, press the 
buttons on both units.

● If a blank portion or disturbed image is played back on the 

player during dubbing, the dubbing may stop so that an 
unusual image is not dubbed.

● Even though the DV cable is connected correctly, 

sometimes the image may not appear in step 

9. If this 

occurs, turn off the power and make connections again.

● If “Playback Zoom” (墌 pg. 16) or “Playback Special Effects” 

墌 pg. 16) is attempted or SNAPSHOT is pressed during 

playback, only the original playback image recorded on the 
tape is output from the DV IN/OUT connector.

● When using a DV cable, be sure to use the optional 

To use this camcorder as a recorder
1) Perform steps 

1 to 4 in “To use this camcorder as a 

player”.
2) Set “REC MODE” to “SP” or “LP”. (

墌 pg. 25, 26)

3) Insert the recording cassette in this camcorder.
4) Press the Recording Start/Stop Button to engage the 
Record-Pause mode.

● The “

” indication appears on the screen.

5) Press the Recording Start/Stop Button to start 
recording. The T indication rotates.
6) Press the Recording Start/Stop Button again to stop 
recording. The T indication stops rotating.

● If no image is displayed on the LCD monitor, set “S/AV 

INPUT” to “OFF”. (

墌 pg. 25, 28)

● Digital Dubbing is performed in the sound mode recorded 

on the original tape, regardless of the current “SOUND 
MODE” setting. (

 

GR-D94US.book  Page 35  Monday, November 17, 2003  2:12 PM