JVC GR-X5AH User Manual

MasterPage: Advan_Heading0_Right

● The time code cannot be reset.

● During fast-forwarding and rewinding, the time 

code indication does not move smoothly.

● The time code is displayed only when “TIME 

CODE” is set to “ON”. (

Enables to check the end of the last recording.
1) Press QUICK REVIEW (3) during the 
record-standby mode.
2) Tape is rewound for about several seconds 
and played back automatically, then pauses in 
the record-standby mode for the next shot.

● Distortion may occur at start of playback. This is 

not a malfunction.

1) Play back a tape or use blank search 
(

墌 pg. 21) to find the spot at which you want to 

start recording, then engage the still playback 
(pause) mode. (See the right column.)
2) Set the power switch to “A” or “M” while 
pressing down the lock button located on the 
switch, then start recording.

Load a cassette. (

Set the VIDEO/MEMORY switch to “VIDEO”.

Set the power switch to “PLAY” while 

pressing down the lock button located on the 
switch.

To start playback, press 4/9.

To stop playback, press 8.

● During stop mode, press 3 to rewind, or 5 to 

fast-forward the tape.

To control the speaker volume
Slide the power zoom lever (VOL. +, –) towards 
“+” to turn up the volume, or towards “–” to turn 
down the volume.

● The playback picture can be viewed in the LCD 

monitor or on a connected TV. (

● If Stop mode continues for 5 minutes when power 

is supplied from a battery, the camcorder shuts off 
automatically. To turn on again, set the power 
switch to “OFF”, then to “PLAY”.

● When a cable is connected to the S/AV connector, 

the sound is not heard from the speaker.

Pauses during video playback.
1) Press 4/9 during playback.
2) To resume normal playback, press 4/9 
again.

● If still playback continues for more than about 

3 minutes, the camcorder’s Stop mode is 
automatically engaged.

A

4/9

3

8

5

GR-XASIA.book  Page 20  Tuesday, April 12, 2005  8:52 PM