JVC GR-X5AH User Manual
EN
49
EDITING
MasterPage: Start_Right
● Never connect the USB cable and the DV
cable simultaneously to the camcorder.
Connect only the cable you wish to use to the
camcorder.
Connect only the cable you wish to use to the
camcorder.
● When using a DV cable, be sure to use the
optional JVC VC-VDV206U or VC-VDV204U DV
cable depending on the type of DV connector
(4 or 6 pins) on the PC.
cable depending on the type of DV connector
(4 or 6 pins) on the PC.
● If the PC connected to the camcorder via the USB
cable is not powered, the camcorder does not
enter the USB mode.
enter the USB mode.
● The date/time information cannot be captured into
the PC.
● Refer to the instruction manuals of the PC and
Software.
● The still images can also be transferred to a PC
with a DV connector-equipped capture board.
● The system may not work properly depending on
the PC or capture board you are using.
You can record a new scene into a previously
recorded tape, replacing a section of the original
recording with minimal picture distortion at the in
and outpoints. The original audio remains
unchanged.
recorded tape, replacing a section of the original
recording with minimal picture distortion at the in
and outpoints. The original audio remains
unchanged.
● Use the provided remote control.
NOTES:
● Before performing the following steps, make sure
● Insert editing is not possible on a tape recorded in
the LP mode or on a blank portion of a tape.
1
Play back the
2
Press REW (
3
)
until the edit-in point is located, then press
PAUSE (9).
PAUSE (9).
3
Press and hold INSERT (I) on the remote
control, then press PAUSE (9). The “9I”
indicator and the time code (min.:sec.) appear
and the camcorder enters insert-pause mode.
indicator and the time code (min.:sec.) appear
and the camcorder enters insert-pause mode.
4
Press START/STOP to begin editing.
● Confirm the insert at the time code you checked in
step
1.
● To pause editing, press START/STOP. Press it
again to resume editing.
5
To end insert editing, press START/STOP,
then STOP (8).
NOTES:
● Program AE and special effects (墌 pg. 44, 45)
can be used to spice up the scenes being edited
during insert editing.
during insert editing.
● During insert editing, the date and time
information changes.
● If you perform insert editing onto a blank space on
the tape, the audio and video may be disrupted.
Make sure you only edit recorded areas.
Make sure you only edit recorded areas.
● During insert editing, when the tape moves to
scenes recorded in the LP mode or a blank
portion, insert editing stops. (
portion, insert editing stops. (
Insert Editing
PAUSE
STOP
REW
INSERT
START/
STOP
GR-XASIA.book Page 49 Tuesday, April 12, 2005 8:52 PM