Sony NSC-GC1 User Manual

Page of 32
29
Precautions
[
Do not use/store the camera in 
the following places
• In an extremely hot, cold or humid place
In places such as in a car parked in the sun, the 
camera body may become deformed and this 
may cause a malfunction.
• Under direct sunlight or near a heater
The camera body may become discolored or 
deformed, and this may cause a malfunction.
• In a location subject to rocking vibration
• Near strong magnetic place
• In sandy or dusty places
Be careful not to let sand or dust get into the 
camera. This may cause the camera to 
malfunction, and in some cases this malfunction 
cannot be repaired.
[
On carrying
Do not sit down in a chair or other place with the 
camera in the back pocket of your trousers or 
skirt, as this may cause malfunction or damage the 
camera.
[
On cleaning
Cleaning the LCD screen
Wipe the screen surface with an LCD cleaning kit 
(not supplied) to remove fingerprints, dust, etc.
Cleaning the lens
Wipe the lens with a soft cloth to remove 
fingerprints, dust, etc.
Cleaning the camera surface
Clean the camera surface with a soft cloth slightly 
moistened with water, then wipe the surface with 
a dry cloth. Do not use the following as they may 
damage the finish or the casing.
• Chemical products such as thinner, benzine, 
alcohol, disposable cloths, insect repellent, 
sunscreen or insecticide, etc.
• Do not touch the camera with the above on your 
hand.
• Do not leave the camera in contact with rubber 
or vinyl for a long time.
[
On operating temperatures
Your camera is designed for use under the 
temperatures between 0°C and 40°C (32°F and 
104°F). Shooting in extremely cold or hot places 
that exceed this range is not recommended.
[
On moisture condensation
If the camera is brought directly from a cold to a 
warm location, moisture may condense inside or 
outside the camera. This moisture condensation 
may cause a malfunction of the camera.
If moisture condensation occurs
Turn off the camera and wait about an hour for the 
moisture to evaporate. Note that if you attempt to 
shoot with moisture remaining inside the lens, you 
will be unable to record clear images.
[
To remove the built-in battery
On disposal of the camera, take the following 
steps to remove the built-in battery
1
Make sure your camera has been 
disconnected from the power source.
2
Open the “Memory Stick Duo” cover 
(page 8) and loosen off the two screws 
using a cross-head screwdriver.
3
Insert a flat-bladed screwdriver, etc., into 
the groove [A] and lift the cover up in the 
direction of the arrow until the cover does 
not lower back down.