Sony DSC-P43 Manual

Page of 124
94
Shooting still images / movies
The power cannot be 
turned on.
• The batteries are not installed properly.
• The AC Adaptor (not supplied) is disconnected.
• The batteries are discharged.
• The batteries are dead (page 113)
p Properly install the batteries (page 12).
p Connect it securely to your camera (page 15).
p Install charged batteries or replace with new ones (pages 11, 
12).
p Replace the batteries with new ones.
The power turns off 
suddenly. 
• If you do not operate the camera for about three 
minutes while the power is on, the camera turns 
off automatically to prevent wearing down the 
battery (page 16).
• The batteries are discharged. 
p Turn on the camera again (page 16).
p Install charged batteries or replace with new ones (pages 11, 
12).
Symptom
Cause
Solution
The LCD screen is not 
turned on even when the 
power is turned on.
• The power was turned off with the LCD screen 
turned off the last time you used the camera.
p Turn on the LCD screen (page 31).
The subject is not visible 
on the LCD screen.
• The mode switch is not set to 
 or 
.
p Set it to 
 or 
 (pages 24 and 74).
The shooting image is not 
displayed on the LCD 
screen during a movie 
shooting (DSC-P43 only).
• The image size is set to [640 (Fine)] when the A/
V connecting cable is connected to the A/V OUT 
(MONO) jack.
p Disconnect the A/V connecting cable.
p Set the image size to any setting other than [640 (Fine)].
The image is out of focus.
• The subject is too close. 
• When shooting still images, 
 (Camera) is set 
to  
or  .
• You have set the focus preset distance.
p Make sure to position the lens farther away from the subject 
than the minimum shooting distance of 10 cm (4 inches) when 
shooting (page 24)
p Set it to any position other than 
 or 
p Set to the auto focus mode (page 51).
Unable to zoom.
• The mode switch is set to 
.
p You cannot use the zoom function when you shoot a movie.
Symptom
Cause
Solution