CBC ZN-L8210NHA User Manual
v2.0 - English
18
Alarm IP address:
You can enter the IP addresses of a possible receiver.
Remote receiver password:
Here you can enter the respective receiver password in case the receiver is
protected by one.
protected by one.
Live video auto-connect:
Select the option On if it is required to re-establish a connection to the previously
specified IP address after each restart, e.g. after a connection breakdown or network
dropout.
specified IP address after each restart, e.g. after a connection breakdown or network
dropout.
The addresses will be contacted in turn once until a connection is
established.
Alarm settings
ó Motion detector
The camera contains an integrated video sensor, which based on the video processing can
register changes in the video signal. These changes are primarily initiated by movement in
the field of view of the camera. The sensitivity of the video sensor can be adjusted, so that
an alarm is generated only if a given threshold is exceeded.
register changes in the video signal. These changes are primarily initiated by movement in
the field of view of the camera. The sensitivity of the video sensor can be adjusted, so that
an alarm is generated only if a given threshold is exceeded.
In order for the alarm to operate, the following conditions must be fulfilled:
Ø motion detection must be activated.
Ø at least one cell must be activated.
Ø parameters must be matched to environmental conditions and to required responses.
Ø the sensitivity must be set to a value greater than 0.
Ø at least one cell must be activated.
Ø parameters must be matched to environmental conditions and to required responses.
Ø the sensitivity must be set to a value greater than 0.
Light reflections, switching on or off of floodlights or light level changes caused
by cloud movement in bright daylight can cause undesirable responses from
the video sensor and thereby generate false alarms. Test for different day and
night time conditions in order to ensure correct operation of the video sensor.
For surveillance of indoor areas, ensure a constant lighting of the areas during
the day and at night. Uniform surfaces without contrast can trigger false alarms
even with uniform lighting.
by cloud movement in bright daylight can cause undesirable responses from
the video sensor and thereby generate false alarms. Test for different day and
night time conditions in order to ensure correct operation of the video sensor.
For surveillance of indoor areas, ensure a constant lighting of the areas during
the day and at night. Uniform surfaces without contrast can trigger false alarms
even with uniform lighting.