Philips AZAZ1301 User Manual

In the stop position, select and store your CD tracks in

the desired sequence. Up to 20 tracks can be stored in

the memory.

1. Press SEARCH 

∞ or § on the set to select your

desired track number.

2. Press PROG.

™ Display: PROG, Prog briefly and your 

selected track number. (See 5)

™ If you attempt to program without first 

selecting a track number, noSE is shown.

3. Repeat steps 1-2 to select and store all desired

tracks.

™ Display: FULL if you try to program more

than 20 tracks.

In the stop position, press and hold PROG until the

display shows all your stored track numbers in

sequence.

You can erase the program by either:

• pressing 

9 twice

™ CLr is displayed briefly and PROG

disappears.

• You select AM / FM function.

• Open the CD door.

SAFETY & MAINTENANCE INFORMATION 
(See 7)

• Don't expose the set, batteries, CDs to humidity,

rain, sand or excessive heat.

• Clean the set with a dry cloth. Don't use any 

cleaning agents containing alcohol, ammonia, 

benzene or abrasives as these may harm the set.

• Place the set on a hard and flat surface so that the

system does not tilt. Make sure there is good 

ventilation to prevent the set overheating.

• Apparatus shall not be exposed to dripping or

splashing.

• Do not place any sources of danger on the 

apparatus (e.g. liquid filled objects, lighted 

candles).

• The mechanical parts of the set contain 

self-lubricating bearings and must not be oiled or

lubricated.

• If the CD player cannot read CDs correctly, use a

cleaning CD to clean the lens before taking the set

to repair.

• The lens of the CD player should never be touched!

• Sudden changes in the surrounding temperature

can cause condensation on the lens of your CD

player. Playing a CD is then not possible. Do not

attempt to clean the lens but leave the set in a

warm environment until the moisture evaporates.

• Always close the CD door to avoid dust on the lens.

• To clean the CD, wipe in a straight line from the

center towards the edge using a soft, lint-free

cloth. Do not use cleaning agents as they may

damage the disc.

• Never write on a CD or attach any stickers to it.

– Volume not adjusted
• Adjust the VOLUME
– Power cord not securely connected
• Connect the AC power cord properly
– Batteries drained/ incorrectly inserted
• Insert (fresh) batteries correctly
– Headphones connected to the set
• Disconnect headphones

– Electrical interference: set too close to TV, VCR or

• Move the set to increase the distance

– Weak radio signal
• FM: Adjust the FM telescopic antenna

nocd indication

– CD badly scratched or dirty
• Replace/ clean CD, see Maintenance
– Laser lens steamed up
• Wait until lens has cleared

nFcd indication

– CD-R(W) is blank/ not finalized
• Use a finalized CD-R(W)

dAtA indication

– CD contains non-audio files
• Press SEARCH 

∞ or § once or more to skip to a

CD audio track, instead of the data file

– CD damaged or dirty
• Replace or clean CD
– SHUFFLE or PROG is active
• Switch off SHUFFLE / PROG

Remote control does not function properly 
(For AZ1325 only)

– Batteries exhausted/ incorrectly inserted
• Insert (fresh) batteries correctly
– Distance/ angle between the set too large
• Reduce the distance/ angle

We have done our best to reduce the packaging and make it easy to separate into 3 materials:
cardboard, expandable polystyrene, polyethylene.

If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service center.