Hitachi VM-E625LA User Manual
General Maintenance
- 49 -
3. Fit the projection of the eye cup into the groove in the viewfinder and rotate the eye cup in the direction of the
arrow.
arrow.
Periodic Maintenance
A precision electromechanical device, the Hitachi VM-E625A requires maintenance after a period of normal use.
We expect that no other maintenance other than head cleaning will be required during the period of warranty
unless the camcorder is used either heavily or seldom. Defective parts are covered by the warranty. Normal
maintenance is the responsibility of the owner. Consult your dealer or local VCR service center for
recommendations regarding normal maintenance based on your use patterns, location, and the age of the
camcorder.
We expect that no other maintenance other than head cleaning will be required during the period of warranty
unless the camcorder is used either heavily or seldom. Defective parts are covered by the warranty. Normal
maintenance is the responsibility of the owner. Consult your dealer or local VCR service center for
recommendations regarding normal maintenance based on your use patterns, location, and the age of the
camcorder.
Troubleshooting
Quality is very important at Hitachi. We inspect and check every camcorder carefully at the factory under the most
rigid quality control and inspection systems. If problems develop please check the following possible solutions
before inquiring about professional service.
rigid quality control and inspection systems. If problems develop please check the following possible solutions
before inquiring about professional service.
INSERTING OR REMOVING THE CASSETTE
Symptom
Check Point & Correction
Cassette holder cannot be opened
when you slide EJECT switch
when you slide EJECT switch
§ • Connect the power source
Cassette cannot be inserted into
cassette compartment
cassette compartment
§ Load cassette in direction indicated
by arrow on cassette
§ Cassette window must be toward
outside.
CAMERA RECORDING
Symptom
Check Point & Correction
Picture does not appear in the
viewfinder or LCD monitor.
viewfinder or LCD monitor.
§ Remove the lens cap.
§ Slide the CAM/OFF/VIDEO switch
to CAM.
§ Disconnect the AV input cable from
the camcorder.
The camcorder cannot go into the
recording mode, even when the
start/stop button is pressed.
recording mode, even when the
start/stop button is pressed.
§
Check the record-protect tab on the
cassette. See page 19 for details.
cassette. See page 19 for details.
§
Push the cassette holder embossed
PUSH LOCK to close it.
PUSH LOCK to close it.
§
Slide the CAM/OFF/VIDEO switch to
CAM.
CAM.
Picture is out of focus.
§ Make sure that FOCUS does not
appear in the viewfinder or LCD
monitor. If it is displayed, press
FOCUS Control buttons to erase it.
monitor. If it is displayed, press
FOCUS Control buttons to erase it.