Gateway GW5-9210-8 Leaflet

Page of 2
INSTALL GUIDE
ice4Link
  Gateway 500 MOST
State of the art car integration
for media players, USB and 
Bluetooth devices
GW5-9210-8
Set the DIP switches to the following 
position and install the Gateway 
500 as illustrated below:
2
3.
Car side
CDC
1a.
Remove the blue locking clip from the 
middle of the fibre optic housing.
Strain the hook carefully with a 
sharp tool, while pulling out the 
optical fibre from the housing.
1b.
1c.
Installation Type 1:
Vehicles supporting multiple CD changers
and equipped with a CD changer
•  Audi A4/S4/RS4/A5/A6/S6/RS6/A8/Q7 
  with MMI-2 High (colour)
These  vehicles  allow  selection  of  Gateway  audio  sources 
and the original CD changer through the existing car audio 
controls.
1
Introduction
Gateway 500 emulates a CD changer and uses CD changer controls to access 
offboard  audio  sources  including  iPod,  USB  devices  and  Dension  Gateway 
accessories. If your car is not already equipped with a CD changer, it may be 
necessary  to  have  the  car  programmed  by  your  dealer  in  order  to  use  the 
GW500 with it.
Programming the car for GW500
Audi
No programming required
BMW non iDrive-4
If original CD changer fitted and MP3 capability is available: no programming 
is required.
If original CD changer fitted and no MP3 capability is available:
 
a) Retrofit “KMP3” option with service computer
 
b) Used in non text capable BMW mode
If original CD changer not fitted or E60 M-ASK used: install GW500 and retrofit 
“IPOD” option with service computer
BMW with iDrive-4
If original CD changer fitted: no programming is required 
If  original  CD  changer  not  fitted:  install  an  original  BMW  CD  changer  and 
retrofit “CD Changer” temporarily option with service computer
Mercedes
Generally no programming is required but in some cases (e.g. no device was 
connected onto the optical ring) it is needed to enable a CD changer with the 
service computer.
Porsche
Generally it is needed to enable a CD changer with the service computer but 
in rare cases the PCM accept the GW500 without this enabling process.
Saab 9-3
It  is  needed  to  enable  a  CD  changer  with  the  service  computer  using  an 
original CD changer.
Installation Type 2a:
Vehicles with an existing CD changer
These vehicles allow selection of Gateway audio sources and 
the original CD changer by switching the mode between CD 
Changer and Gateway mode.
Audi (MMI-2 Basic Monochrome)
Saab 9-3 (Rear CDC)
Porsche (CDR 23/24 and PCM I/II/2.1)
for longer CDC and car side cable use 
FOA1PO1
Mercedes  (NTG1-,  NTG2-  Audio  20/50  and 
Comand)
CDR
PCM
Text capable BMW E87, E90, E91, E92, E93, 
E60/61, E63/E64, E65/E66 (03/2005-), E70 
and Mini (non iDrive-4)
Non text capable BMW E65/E66 (-03/2005) 
(non iDrive-4)
3
Package Content & Electrical Installation
1
2
3
DIP
 
switch
Car side
CDC
 
side
Power
harness
4
Power harness:
-red wire
(+12V non switched)
-black (GND)
Car side
CDC side
BMW E90, E91, E92, E93 with iDrive-4