Crimestopper Security Products CS-2000DPII User Manual

Page of 20
 
 
 
 
 
 
CS-2000DPII Series IV 
With Data Port Technology 
 
REMOTE CONTROL ALARM SYSTEM 
INSTALLATION & OPERATING INSTRUCTIONS 
 
 
INTRODUCTION 
 
CONGRATULATIONS  on  your  choice  of  an  On-Guard  Series  Remote  Alarm  System  with  Data  Port 
Technology  by  Crimestopper  Security  Products  Inc.    This  booklet  contains  the  information  necessary  for 
installing, using, and maintaining your alarm system.  If any questions arise, contact your installation dealer or 
Crimestopper Security Products Inc. at the Tech Support number below. 
 
 IMPORTANT INFORMATION: Primary and Optional Features: 
-PRIMARY:
  These  are  features that  must be  connected in  order  for  the system to  operate properly; i.e. the 
Siren, L.E.D., 12V Power, Ground, Door pin, Flashing Lights and Override Program Valet Button etc. 
 
-OPTIONAL:    These  are  features  to  be  connected  if  desired  or  agreed  upon  by  the  installing  dealer.  These 
features may also require additional parts and/or labor fees.  Consult with your installer beforehand; i.e. Door 
Locks, Flashing Lights, Starter disable, Hood Trunk trigger, and Auxiliary Remote Outputs etc. 
 
This installation book is designed for the installer or individual with an existing understanding of automotive 
electrical systems, along with the ability to test and connect wires for proper operation.  To ease installation, 
we  suggest  that  you  READ  THIS  MANUAL  before  beginning  your  installation.    This  book  is  provided  as  a 
GENERAL GUIDLINE and the information contained herein may differ from your vehicle. 
 
    TECH SUPPORT 
Mon-Fri 8:00 AM-4:30 PM Pacific Time 
        (800) 998-6880 
 
REV. D 1.2007 
This device complies with FCC Rules part 15. Operation is subject to the following 
two  conditions:  1)  This  device  may  not  cause  interference,  and  (2)  this  device 
must accept any interference that may be received, including interference that may 
cause undesired operation.  The manufacturer is not responsible for any radio or 
TV  interference  caused  by  unauthorized  modification  to  this  equipment.  Such 
modification could void the user's authority to operate the equipment.