Sierra Housewares S5011 User Manual
46
6
Maintenance
Common System Messages
Below is an explanation of the common messages your keypad
might display. Beside each message is a discussion of what re-
sponses are appropriate. If you find the response is ineffective,
call your local C&K service representative.
might display. Beside each message is a discussion of what re-
sponses are appropriate. If you find the response is ineffective,
call your local C&K service representative.
In the table below, the ellipses (...) represent the specific informa-
tion, such as zone numbers, that follows the system message.
tion, such as zone numbers, that follows the system message.
If you notice
That means
What to do:
Power LED is off
The system is not
Verify that the rest of the
receiving AC (house
building is receiving power;
current) power
then call for service.
That
Display reads:
A zone is faulted;
Correct the fault (by
"Faulted..."
cannot fully arm
closing doors/windows); or
bypass the zone.
bypass the zone.
Display reads:
A sensor needs
Bypass the sensor, or
"Trouble..."
service
arrange for repair.
Display reads:
A sensor may have
Call for service.
"Tamper..."
been tampered with
Display repeatedly
A sensor may need
Call for service.
reads: "Trouble..."
service
"Tamper..."
Display reads:
Any one of your
Depending upon your
Ready"
sensors may be
arming type, your system
faulted
may be able to arm. If not,
correct any faulted zones,
then attempt to arm.
correct any faulted zones,
then attempt to arm.
Display reads
An alarm occurred
Refer to "Resetting After an
"Alarm..."
Alarm" in Section 4.
Display reads
A zone has been
Remember the zone is
"Bypass..."
bypassed
unprotected while bypassed.
You can remove the bypass
(see Section 3), or arm/
disarm with bypass in place.
You can remove the bypass
(see Section 3), or arm/
disarm with bypass in place.