Heath Zenith MSL360FWPB User Manual
Pentamark LLC
598-1351-01
Requirements
• The light control requires 120-volts AC.
• If you want to use Manual Mode, the control must be
• If you want to use Manual Mode, the control must be
wired through a switch.
•
Some codes require installation by a qualified
electrician.
electrician.
• This product is intended for use with the enclosed
gasket and with a junction box marked for use in wet
locations.
locations.
Light Control
Sensors
Cover
Plate
Lamp Holders
Features
• Turns on lighting when motion is detected.
• Automatically turns lighting off.
• Photocell keeps the lighting off during daylight hours.
• LED indicates motion was sensed (day or night).
• Automatically turns lighting off.
• Photocell keeps the lighting off during daylight hours.
• LED indicates motion was sensed (day or night).
Plastic Hanger
Rubber Plug
Gasket
Mounting Strap
Mounting Bolt
3 Wire
Connectors
This package includes:
6 Screws
(3 sizes included)
OPERATION
* resets to Auto Mode at dawn.
TEST
10 5 1
TEST
ON-TIME
Put the ON-TIME switch on the
bottom of the sensors in the TEST
position.
bottom of the sensors in the TEST
position.
MANUAL MODE
ON-TIME
10 5 1 TEST
... back on.
AUTO
1 Second OFF
then...
Note: When first turned on wait about 1
1
/
2
minutes for
the circuitry to calibrate.
Manual mode only works at night
because daylight returns the sen-
sors to AUTO.
because daylight returns the sen-
sors to AUTO.
Flip the light switch off for one sec-
ond then back on to toggle between
AUTO and MANUAL MODE.
ond then back on to toggle between
AUTO and MANUAL MODE.
Manual mode works only with the
ON-TIME switch in the 1, 5, or 10
position.
ON-TIME switch in the 1, 5, or 10
position.
Put the ON-TIME switch in the
1, 5, or 10 minute position.
1, 5, or 10 minute position.
Mode:
On-Time:
Works:
Day
Night
Test
5 Seconds
x
x
Normal
1, 5, 10 min.
x
Manual
Until Dawn*
x
Model MSL360FWPB
Motion Sensor
Light Control
Light Control
Meets the ENERGY STAR
®
guidelines
when used with 120 W Max bulbs.
2 Shells