Heath Zenith 9700LeD User Manual

Dated receipt required for warranty replacement.

•  Automatically comes on when motion is detected.
•  Automatically turns light off.
•  Photocell  keeps  the  light  off  during  daylight

hours.

•  LED indicates motion was sensed (day or night).

•  The light control requires 120 volts AC.
•  If  you  want  to  use  Manual  Override  mode,  the

control must be wired through a switch.

 

nOtiCe: Not to be used on light dimmer or timer-
controlled circuits.

•

•  This product is intended for use with the enclosed

gasket and with a junction box marked for use in
wet locations.

•  This  light  fixture  has  been  tested/certified  using

Lights  of  America  LED  Lamp  Model  Numbers
2003LEDP38-65K,  2002LEDR30-65K,  and
2002LEDP30-65K.

Be sure to remove all contents from packaging and
verify all items are present before assembling this light
fixture. This package includes the following items:
•  Security Light
•  Two LED PAR38 lamps
 (Lights of America Model: 2003LEDP38-65K)
•  Two decorative lamp shells
•  Mounting Strap
•  Plastic Hanger
•  Rubber Plug
•  Mounting hardware
•  Wire nuts
•  Owner’s Manual

© 2008

598-1360-00

For easy installation, select an existing light with a
wall switch for replacement.
For best performance, mount the fixture about 8 ft.
(2.4 m) above the ground.

nOte: If fixture is mounted

higher than 8 ft. (2.4 m), aiming the sensor down will
reduce coverage distance.

1.  Swing the sensor head towards the clamp screw

joint.

For under eave installation, the sensor head must 
be rotated as shown in the next two steps for proper
operation and to avoid the risk of electrical shock.

Controls

Controls

Controls

Clamp Screw

2.  Then rotate the sensor head clockwise 180° so

the controls face down.

If the sensor pops out of the ball joint, loosen the
clamp screw and push the sensor back into the ball
joint. Tighten the clamp screw when done.