Desa 5511 User Manual
3
598-1310-00
SPECIFICATIONS
Range . . . . . . . . . . . . . Up to 60 ft. (18.3 m); [varies with
surrounding temperature]
Sensing Angle . . . . . . . Up to 110°
Electrical Load . . . . . . . Up to 150 Watts Maximum
Electrical Load . . . . . . . Up to 150 Watts Maximum
tungsten
Power Requirements . . 120 VAC, 60 Hz
Operating Modes . . . . . TEST, AUTO and MANUAL
Operating Modes . . . . . TEST, AUTO and MANUAL
MODE
Time Delay . . . . . . . . . 1, 5, or 10 minutes
Sensitivity . . . . . . . . . . Adjustable
Replacement lamp . . . . T 150W (or less) halogen 120
Sensitivity . . . . . . . . . . Adjustable
Replacement lamp . . . . T 150W (or less) halogen 120
VAC
DESA Specialty Products reserves the right to dis-
continue products and to change specifi cations at any
time without incurring any obligation to incorporate new
features in products previously sold.
continue products and to change specifi cations at any
time without incurring any obligation to incorporate new
features in products previously sold.
TEST AND ADJUSTMENT
❒ Turn on the circuit breaker and light switch.
NOTE: Sensor requires about 1
1
/
2
minutes to calibrate
before it will detect motion. When fi rst turned
on, wait about 1
on, wait about 1
1
/
2
minutes.
Avoid aiming the control at:
• Objects that change temperature rapidly, such as
heating vents and air conditioners. These heat
sources could cause false triggering.
sources could cause false triggering.
• Areas where pets or traffi c may trigger the control.
• Nearby large, light-colored objects refl ecting light
may trigger the shut-off feature. Do not point other
lights at the sensor.
lights at the sensor.
60 ft.
(18.3 m)
The control is most sensitive to motion across it.
Motion
Sensor
Motion
❒ Loosen the clamp screw in the
sensor ball joint and gently
rotate the sensor to aim.
rotate the sensor to aim.
❒ Walk through the coverage
area noting where you are
when the lights turn on. Move
the sensor head up, down, or
sideways to change the cover-
age area. Keep the sensor at
least 1" (25 mm) away from
the lamps.
when the lights turn on. Move
the sensor head up, down, or
sideways to change the cover-
age area. Keep the sensor at
least 1" (25 mm) away from
the lamps.
❒ Set SENSITIVITY as needed.
Too much sensitivity may
increase false triggering.
increase false triggering.
❒ Secure the sensor head into
position by tightening the
clamp screw. Do not over-
tighten the screw.
clamp screw. Do not over-
tighten the screw.
❒ Set the amount of TIME the
lights stay on after motion is
detected. It is selectable from 1, 5, or 10 minutes.
detected. It is selectable from 1, 5, or 10 minutes.
Bottom of Sensor
ON-TIME
10 5 1 TEST
MIN MAX
SENS
8 ft.
(2.4 m)
110°
❒ Turn the SENSITIVITY (SENS) control to the mid
position and the ON-TIME control to the TEST
position.
position.
Aim Sensor
Down for Short
Coverage
Aim Sensor
Higher for Long
Coverage
Clamp
Ball
Joint
Joint
Maximum
Range Maximum
Coverage
Angle
Least Sensitive
Most Sensitive