Monte Carlo Fan Company 5SLR52 User Manual

Hang assembled fan from the mounting bracket

installed to ceiling in previous step.  Make sure

the fan is hanging straight.  Rotate fan until the

tab on the Mounting bracket engages the slot

on the Downrod Ball.  This must be done to

prevent the fan body from rotating when the

blades are in motion.

Make sure the studs protruding from the

bottom of the Mounting bracket are

installed with threads all the way through

the bracket.  

Place downrod into fan yoke.

Install the keeper to pin.

Tighten the 2 set screws on the yoke

once the downrod is in place.

Align the hole in the downrod with

the hole in the yoke. Insert th pin

through the yoke and downrod until

the point appears on the other side.

Thread leadwires and safety cable

through downrod. (as shown)

Place yoke cover on downrod. (as

shown)

Pull down yoke cover.

Install remote receiver into mounting

bracket.

Set dip switches on the Remote Transmitter and

Remote Receiver to the same settings. This must be

done so the units will communicate properly. If you

have other fans you can set to control from one trans-

mitter by setting both receivers the same as the

transmitter. If you have more than one fan with

remote. You can set the dip switches to different posi-

tions to have seperate control. 

Remote Transmitter

Dip switches

Remote Receiver Dip

switches

Fan and light kit combinations over 35 lbs,

in both flush and downrod mode the safety

cable must be installed into the house struc-

ture beams using the 3” lag screws,washers,

and lock washers. provided.  Make sure that

when the safety cable is fully extended the

lead wires are longer than the cable and no

stress is placed on the lead wires. 

Safety cable installation

safety

cable

3” lag

screw

lock

washer

washer