Monte Carlo Fan Company 5WF52XXD User Manual

Tighen keeper nut onto threaded

pipe from the light kit.

Lift canopy to ceiling aligning the key

hole slots with the screws on the bottom

of the mounting bracket. Rotate the

canopy counter clockwise to lock in place.

Tighten the screws to secure the canopy.

See insert for key hole shape. 

Hang assembled fan from the mounting bracket

installed to ceiling in previous steps.  Make sure the

fan is hanging straight.  Rotate fan until the tab on

the Mounting bracket engages the slot on the

Downrod Ball.  This must be done to prevent the fan

body from rotating when the blades are in motion.

Install keeper nut over lead wires.

Make wire connections to power source using wire
nuts provided.  Make sure that no filiments are out-
side of the wirenut. After making the wire connec-
tions, the wires should be spread apart with the
grounded conductor and the equipment-grounding
conductor on one side of the outlet box and
ungrounded conductor on the other side of the outlet
box.  

Check the motor for plastic shipping sta-

bilizer tabs and remove them if they are

present.

Remove the 3 screws in round holes.

Remove cap by twisting and pulling

down. Save screws.

Install switch housing to light kit by

turning clockwise to tighten.

Attach blade brackets to blades

using the blade bracket screws

and washers provided.

The screws, washers, and motor

pads are pre-installed to the blade

holders. Attach blade assembly to

motor and tighten screws securely.

Connect black and blue wire from fan to

Black or (Hot) wire from house.  Connect

White wire from Fan to White (Neutral)

wire from house.  Connect Ground leads

from mounting bracket and downrod to

Ground lead from house.  Refer to

Blue 

Black

White

Green

Black

White

Ground

For Canadian installation and for USA fan and

light kit combinations over 35 lbs, in both flush

and downrod mode the safety cable must be

installed into the house structure beams using

the 3” lag screws,washers, and lock washers.

provided.  Make sure that when the safety cable

is fully extended the leadwires are longer than

the cable and no stress is placed on the lead-

wires.

Safety cable installation

safety

cable

3” lag

screw

lock

washer

washer