Monte Carlo Fan Company 5RDR User Manual

Install 3 screws to hold glass to fan

housing.  Do not overtighten as this

could crack the glass.

Pull lead wires and safety cable out

from the yoke about 3”.

Lower upper glass disk onto fan housing and

align 3 holes in glass with 3 holes in fan hous-

ing.

Lift mounting neck to mounting Plate and align

screws. 

Secure mounting neck to the mounting plate

with 6 screws to become a complete mounting

bracket.

Raise lead wire, safety cable, and

downrod  up and align with slot for

pin in bottom of arch yoke. Push pin

into hole in downrod. After putting

in pin don’t twist downrod. Make

Tighten set screws to hold downrod

securely in the arch yoke.

Place downrod into the arch yoke

and align the slot in arch yoke and

the hole in the downrod. 

Place arms over the fan housing.

Make sure the arms with electrical

connection plugs are next to the

plugs on the fan housing.

Remove pin from downrod and save

for later step 14. Push the yoke

cover onto downrod. Thread lead

wires and safety cable through the

downrod.  

Remove screw and nut on tab to

place arch arms in place. Save screw

and nut for use later step 19.

Close up for showing tab and screw

holes of fan body to place arch arms

over for arch installation.