Monte Carlo Fan Company 5DH52 User Manual

Install the screws removed in step # 5 and

tighten all screws.

Attach blade brackets to blades using the blade

bracket screws and washers provided.

For control of fan and optional light from wall

location, follow diagram above. NOTE: A pro-

Lift decorative motor housing to slide over

mounting plate, align with the two remaining

screws in the mounting plate with the “L” shape

holes and twist clockwise to lock.

Wiring option with wall speed control

Remove plastic shipping stabilizer tabs from

motor, if present. The screws, washers and

motor pads are pre-installed to the blade hold-

ers. Attach blade assembly to motor by tighten-

ing first screw one turn, then tighten second

screw securely. Then, go back and tighten first

screw securely.

After attaching blade; reinstall the switch hous-

ing using the three screws previously removed.

Lift motor into place aligning studs on mounting

plate with holes on the motor bracket. Install

and tighten four locking nuts to studs. Tighten

firmly. Use 7/16” wrench or pliers.

Installation

After installation, please refer to operation, maintenance and troubleshooting 

sections in  this manual. If your fan is packaged with a light kit or

if you wish to install a separately purchased light kit, please refer 

to the insert sheet titled: Light Kit Installation

For pullchain controls, follow diagram above.

Make sure that all exposed wiring is secured

inside wire nuts. Note: Wires from house may

vary in color and may not include ground wire.

After wiring is conplete, gently push wires into

junction box with wire nuts pointing upward.

Refer to point 3 of safety tips.

House

Fan

Black

White

Ground

Black

White

Green(Bracket)

Blue *

Standard wiring option

Green(Downrod)

* Attach blue wire

only if attaching

light kit with fan

Secure with twist-

lock wire connectors

(included)