Monte Carlo Fan Company 5DOR52 User Manual

Tighten yoke set screws securely and evenly.

Loosen the 2 set screws in the yoke. Insert

downrod into yoke, aligning large hole in the

downrod with the large hole in the yoke.  Insert

cross pin though yoke and downrod.

Insert cotter pin in to cross pin to secure.

Thread leadwire and safety cable through

downrod and half ball.

For Canadian installation and for USA fan and

light kit combinations over 35 lbs, in both flush

and downrod mode the safety cable must be

installed into the house structure beams using

the 3” lag screws provided.  Make sure that

when the safety cable is fully extended the

leadwires are longer than the cable and no

stress is placed on the leadwires.

Safety cable installation

Hang assembled fan from the mounting bracket

installed to ceiling in previous step.  Make sure

the fan is hanging straight.  Rotate fan until the

tab on the Mounting bracket engages the slot

on the Downrod Ball.  This must be done to

prevent the fan body from rotating when the

blades are in motion.

Re-install safety bar removed in step. 3  by

placing safety bar on screws, sliding into place,

and tightening the 2 screws.

Thread wires and safety cable through upper

body and install over downrod to fan body. Next

thread wires and safety cable through canopy

and place over downrod.

Loosen two set screws holding half ball, slide

down ball and remove pin. Remove the ball.

Set screws

Thread wires through half ball, put ball back over

downrod and replace pin then tighten the two set

screws.

Set screws

Lift mounting neck to mounting Plate and align

screws. 

Secure mounting neck to the mounting plate

with four screws to become a complete mount-

ing bracket.