Monte Carlo Fan Company 5BGR56 Series User Manual
Tread leadwires and safety cable through the
downrod.
Install 6 15 watt candelabra bulbs included.
Install canopy and yoke cover over the down-
rod.
Place downrod into the yoke, align the holes in
the yoke with the holes in the downrod and
install cross pin.
9
11
12
13
Tighten set screws to hold downrod securely in
the yoke. Drop cover over yoke.
15
Install keeper pin into cross pin.
14
Loosen 4 screws in motor housing then lower
metal disk with glass onto fan by aligning 4
key slot holes in metal housing with 4 screws in
fan housing. Tighten the 4 screws securely.
10
For Canadian installation in both flush and
downrod mode the safety cable must be
installed into the house structure beams using
the 3” lag screws provided. Make sure that
when the safety cable is fully extended the
leadwires are longer than the cable and no
stress is placed on the leadwires.
Canadian mounting only
Safety Cable
Lag Screw
Make wire connections to power source using
wire nuts provided. Make sure that no filiments
are outside of the wirenut. After making the
wire connections, the wires should be spread
apart with the grounded conductor and the
equipment-grounding conductor on one side of
the outlet box and ungrounded conductor on
the other side of the outlet box.
18
Hang assembled fan from the mounting bracket
installed to ceiling. Make sure the fan is hang-
ing straight. Rotate fan until the tab on the
Mounting bracket engages the slot on the
Downrod Ball. This must be done to prevent
the fan body from rotating when the blades are
in motion.
16
Lift mounting neck to mounting Plate and align
screws.
7
Secure mounting neck to the mounting plate
with four screws to become a complete mount-
ing bracket.
8
17