Monte Carlo Fan Company 4CO28 User Manual

Hang fan from mounting bracket by

the hands free hook into a closed

hole on the edge of the Canopy.

Note: For Canadian mounting refer to

Step #8.

For Canadian installation in both flush and down-

rod mode the safety cable must be installed into

the house structure beams using the 3” lag screws

provided.  Make sure that when the safety cable is

fully extended the leadwires are longer than the

cable and no stress is placed on the leadwires.

Hang assembled fan from the mounting bracket

installed to ceiling in previous step.  Make sure the

fan is hanging straight.  Rotate fan until the tab on

the Mounting bracket engages the slot on the

Downrod Ball.  This must be done to prevent the fan

body from rotating when the blades are in motion.

Place canopy on top of the fan motor allowing the

yoke to pass through the large hole in the center of

the canopy.  Align the 3 larger holes around the

center hole with the 3 screws already installed in

the fan.  Install 3 flush mount screws provided into

smaller holes and tighten securely.

Canopy

Center

Hole

Larger

holes

Smaller

holes

Hands free hook

Make wire connections to power source using wire nuts
provided.  Make sure that no filiments are outside of
the wirenut. After making the wire connections, the
wires should be spread apart with the grounded con-
ductor and the equipment-grounding conductor on one
side of the outlet box and ungrounded conductor on
the other side of the outlet box.  

CCaannaaddiiaann m

moouunnttiinngg oonnllyy

Safety Cable

Lag Screw

Make sure the studs protruding from

the bottom of the Mounting bracket

are installed with threads all the way

through the bracket.  

Pass leadwires  and safety cable

through the canopy.

Remove side covers from canopy

exposing  4 holes.  2 closed holes

and 2 open “L” shape holes.

FFlluusshh M

Moouunntt IInnssttaallllaattiioonn

Lift Canopy allowing the 2 studs

to protrude through the canopy.  

Next lift the canopy disk and install

knurled nuts as shown.  Tighten the

knurled nuts securely.  The canopy should

adjust for any irregularity in the ceiling or

Outlet box.

Connect black and blue wire from fan to Black or (Hot)

wire from house.  Connect White wire from Fan to

White (Neutral) wire from house.  Connect Ground

leads from mounting bracket and downrod to Ground

lead from house.  Refer to Safety Tips section of

Canopy disk

Blue 

Black

White

Green

Black

White

Ground

Lag Screw

Washer

Lock Washer

Safety Cable

Take 4 screws from hardware pack and

insert 2 one on each side of bracket to

match the L slot screw holes in canopy.

Keep 2 screws for later use.  Remove the

all thread studs from the lower part of

the mounting bracket.