Monte Carlo Fan Company 5OBR52 User Manual

Raise fan with downrod assembled to

the ceiling bracket and hang fan

assembly. Be sure to rotate the

downrod ball so that the notch in the

bracket engages the slot in the ball.

Tighten 2 downrod set screws and

lock nuts.

Install keeper into cross pin.

Install downrod into yoke.

Align hole in downrod with hole in

yoke and install cross pin.

Loosen 2 screws with key slots and

remove the 1 screw without ket slot.

Save screw removed. 

Set dip switches on the Remote Transmitter and Remote

Receiver to the same settings.  This must be done so the

units will communcate properly.  If you have other fans you

can set to control from one transmitter by setting both

receivers the same as the transmitter.  If you have more

than one fan with remote.  You can set the dip switches to

different positiosns to have seperate control.

Remote Transmitter Dip swtiches

Remote Receiver Dip switches

For Canadian installation in both flush and

downrod mode the safety cable must be

installed into the house structure beams using

the 3” lag screws provided.  Make sure that

when the safety cable is fully extended the

leadwires are longer than the cable and no

stress is placed on the leadwires.

Canadian mounting only

Make wire connections to power source using

wire nuts provided.  Make sure that no filiments

are outside of the wirenut. After making the

wire connections, the wires should be spread

apart with the grounded conductor and the

equipment-grounding conductor on one side of

the outlet box and ungrounded conductor on

the other side of the outlet box.

Lift Canopy to ceiling aligning the key hole slots

with the screws on the bottom of the Mounting

bracket.  Rotate the canopy Counter Clockwise

to lock in place.  Tighten the screws to secure

the Canopy.  See inset for Keyhole shape

white

Red

Make wiring connections as indicated above.

White from fan to white from remote marked

N.  Orange from fan to Orange from remote

marked Light/up. Blue from fan to blue from

remote marked down light. Black from fan to

Red from remote marked L.  White from

house to white from remote marked AC N .

Black from house to Black from remote

marked AC  L. Connect all green ground wires

to Ground wire from House.

Install remote receiver by sliding into opening in

the Mounting bracket.  Make sure that the dip

switches on the Transmitter and the Receiver

are set to the same position.  See Fig 37 for

remote operation

orange

blue

Green

white
black

House

Fan