Hunter Fan 22710 User Manual

Hunter Fan Company 

42012-01 • 03/09/05 

42012-01 • 03/09/05 

Hunter Fan Company

2-1.  Drill two pilot holes into the wood support structure through the 

outermost holes in the outlet box. e pilot holes should be 9/64” 
in diameter.

    Note: Your fan comes with four pre-installed neoprene noise 

isolators. 

2-2.  read the lead wires from the outlet box down through the hole 

in the middle of the hanger bracket.

2-3.  Align the slotted holes in the hanger bracket with the pilot holes 

you drilled in the wood support structure. For proper alignment 
use slotted holes directly across from each other. If you are 
installing the fan on an angled ceiling, be sure to orient the hanger 
bracket with the large opening towards the ceiling peak.

    Note: e isolators should be flush against the ceiling.
2-4.  Place a flat washer on each of the two 3” screws and pass the 

screws through the slotted holes in the hanger bracket into the 
pilot holes you drilled. 

    Tighten the screws into the 9/64” pilot holes; do not use lubricants 

on the screws. Do not over tighten.

Flat Washer

3” Screw

For Angled Ceilings: Be sure to orient 
the hanger bracket with the large 
opening towards the ceiling peak. 

Hanger 

Bracket

Isolator