CFM UVC36 User Manual

9

2. Attach wire to switch and install switch into recep-

tacle box.  Attach cover plate to switch.

3. Connect wiring to gas valve. (Fig. 10)

Remote switch can be installed on either side of the 
access door.  Simply mount the switch to the switch 
bracket provided.  Screw the bracket on either side of 
the frame, lining up the screws with the pre-punched 
holes. (Fig. 11) 

With the electrical and wall switch wiring connected, 
gently slide or lift the heater to the desired location.

If nailing flanges are not already installed, attach 
flanges with the screws provided.

Make sure heater is level.  Shimming may be required.

Secure heater in place by nailing or screwing through 
nailing flanges into framing.  NOTE: Be sure to allow 
proper space for sheet rock.

CAUTION: All joints between the finished wall and the 
heater surround (top and sides) may be sealed only 
with non-combustible material. Only noncombustible 
material can be applied as facing to the heater surround 
(the black painted face).
When finishing the heater, never obstruct or modify the 
air inlet/outlet top or bottom grilles in any manner.
Finish the wall with the material of your choice. Refer to 
Page 5, Figure 3 for specific clearances when installing 
a combustible mantel or other combustible projection.

Fig. 10   Remote switch wiring.

THTP

TP

TH

FP382

REMOTE SWITCH WIRING - NVC

11/20/96

FP382

ON/OFF

Switch

Valve

IF381

NVC -Remote switch bracket

11/20/96

FP381

Fig. 11  Installing remote switch bracket.

Prepunched 

Holes