Windsor MPRO 10080390 User Manual

86037780  EXTRACTOR  11/21/07 

                       

 
1.  Turn off switch and unplug machine. 

 

2.  Set the machine in its upright position.  Remove 

the screws (2) in the back metal cover.  Rotate 
the cover down and slide back releasing the tab 
under the machine from the main frame. 

 
3.  Remove the pump box cover.  Remove screws 

(4) at each leg of the cover. 

 
4.  To remove brush motor, position the machine to 

have access to the bottom.  Remove screws (2) 
at the sides of the machine holding the brush 
deck pivot axle. 

 
5.  Remove screw mounting belt cover and remove 

belt cover. 

 
6.  Remove the nuts and washers (2) at brush 

motor and slide motor forward to reduce belt 
tension.  Remove belt. 

 
7.  Remove pulley by loosening set screw and pull 

off shaft. 

 
8.  Unplug the brush motor wires from the rectifier 

located in the pump mount housing.  Also, 
remove the ground lug from the stud on the 
main frame by removing the nut on the stud. 

 
9.  Reverse the process to reinstall the motor.  Align 

motor pulley with brush pulley. Check belt for 
proper belt tension. 

 

 

1.  Turn off switch and unplug machine. 
 
2.  Set the machine in its upright position.  Remove 

the screws (2) in the back metal cover.  Rotate 
the cover down and slide back releasing the tab 
under the machine from the main frame. 

 
3.  Remove the pump box cover.  Remove screws 

(4) at each leg of the cover. 
 

4.  To remove either pump, loosen the hose clamp 

and remove the hose from both ends of the 
pump. 

 
5.  Remove screws and washers (4) that mount 

pump housing. 
 

6.  Unscrew the hose fittings from each end of the 

pump. 
 

7.  Flex the pump mounting housing to remove the 

pump. 
 

8.  Remove the screw attaching the ground wire to 

the pump.  Remove the other two wire 
connectors attached to the pump. 
 

9.  Reverse the process to reinstall the pump.