Petsafe LDT-433 User Manual

10 

• Eliminate one misbehaviour or teach one obedience command at a time. If you move too fast 

with the training, your pet may become confused.

• Be consistent. Give your pet an Audible Tone or Stimulation with each misbehaviour.
• Do not over-correct your pet. Use as few Stimulations as possible to train your pet.
• Unless you can supervise him, it is recommended that you restrict your pet from situations in 

which he has a history of misbehaving. However, setting up a situation as a training session can 
dramatically improve your chances of success.

• If your pet reacts to the training by hiding or acting fearful, redirect his attention to a simple and 

appropriate behaviour such as the “Sit” command.

• The Lower Button can be used to deliver a slightly higher Stimulation Level on occasions when 

your pet ignores his Recognition Level. Using this button is a quicker alternative than adjusting 
the Intensity Dial.

• Never use the Remote Trainer to correct or eliminate any form of aggressive behaviour. If you 

are unsure if your pet is aggressive, please consult your veterinarian or a certifi ed trainer.

• The objective is to train your pet to respond to your spoken command and the Audible Tone 

from the receiver in normal circumstances. After proper training, the use of Stimulation should 
only be necessary if your pet repeats unwanted behaviour.

____________________________________________________________________

1. Put a separate, non-metallic collar on your pet’s neck ABOVE the Receiver Collar, and attach a 

3 metre lead. Note: Be sure the extra collar does not put pressure on the Contact Points.

2. Hold your lead and Remote Transmitter in one hand. Press and hold the Side Button to send 

an Audible Tone to your pet while saying “Sit” and if necessary using your free hand to guide 
your pet into a “Sit” position. Release the Side Button immediately when your pet sits. Repeat 
this several times.

3. If your pet sits reliably on receiving the Audible Tone and the spoken “Sit” command, then 

training is complete. Release your pet from the “Sit” position and praise him. If not, move on to 
Step 4.