FIELD CONTROLS FC-2000 User Manual

The media filter MUST be replaced periodically. The 
reason is to maintain appliance operating efficiency 
by minimizing pressure drop through the HVAC 
system. The frequency of filter media replacement 
depends on the operational environment. The need 
for replacement is easily determined by a visual 
inspection.  Note: For optimum performance, replace 
the media filter every 6 to 12 months. 
M

1.  Turn off electrical power to the HVAC system. 
2.  Remove the filter cabinet access panel. 

 “AIR FLOW” directional arrow, located on 

existing media filter (Figure 6). 

3.  Remove the existing filter media. 
4.  Remove the new media filter from the plastic bag. 

 Re-use plastic bag to discard the used 

media filter. 

5.  Check media filter directional arrow 

(→)

! The 

directional arrow MUST point in the direction of 
air flow. 
Tip: 

Write the installation date on media filter 

next to directional arrow for future filter 
replacement reference. 

6.  Install the new media filter. 
7.  Install the filter cabinet access panel. 
8.  Turn on electrical power to the HVAC system. 
R

FC - 1400 

16 x 25 x 5 

3 

FC - 2000 

20 x 25 x 5 

3 

 

P/N 46567000    11/08

Field Controls, L.L.C. warrants that the following Field Controls, L.L.C. products sold hereunder, shall be free from defects in material and workmanship
under normal use for eighteen (18) months from date of manufacturing by the consumer excepting the provisions numbered below. 

1. 

Field Controls shall have no obligation in the event the customer is unable to provide receipt showing the date the customer purchased the
product(s) or accurate date code information. 

2. 

The product must be properly installed, maintained and operated under normal conditions. 

3. 

Field Controls shall not be liable for any consequential and incidental damages, resulting from failure of a Field Controls, L.L.C. product, failure to 
deliver, delay in delivery, delivery in nonconforming condition, or for any breech of contract or duty between Field Controls, L.L.C. and the 
customer. 

4. 

Field Controls, L.L.C. products are often intended for use in specific applications. Field Controls, L.L.C. makes no warranty if a Field Controls, 
L.L.C. product is used in applications other than intended. 

5. 

Field Controls, L.L.C. makes no warranty of any kind in regard to any other manufacturer’s products distributed by Field Controls, L.L.C. Field 
Controls, L.L.C. will pass on all warranties made by the manufacturer and where possible, will expedite the claim on behalf of the customer, but 
ultimately, responsibility for disposition of the warranty claim lies with the manufacturer.